Reasons for blackening of equipment bottom of low nitrogen burner

Reasons for blackening of equipment bottom of low nitrogen burner
On the basis of traditional burners, low nitrogen burners add fans, frequency converters, control valves and integrated circuits to enable clean energy and burner operation to provide heat energy for boilers. Why does the bottom turn black when it is used?
If the low nitrogen burner is used for too long, the flame will burn red and the furnace bottom will often blacken. The reason for this is that oil and dust fall into the holes of the incinerator. At this time, the incinerator can be dismantled, the old toothbrush can be used to brush the periphery of the incinerator hole, and then the thin lead wire can be used to poke one by one, and then the impurities can be removed by knocking on the table several times. If there are pumps, blow one by one at the small holes.
If the flame of the cleaned low nitrogen burner is still red, the nozzle is stained with dirt. Remove the incinerator, expose the nozzle, and poke it with hard plastic wire or brown hair for several times. Never use copper, iron and other metal wires to avoid roughening the air hole of the nozzle and affecting the use effect of the nozzle. Then install the incinerator, and the flame will turn blue.

The series of products are designed and classified, with different physical and chemical properties and incineration functions, which are highly targeted and applicable. The economic operation mode is adopted, so as to achieve the purpose of full atomization, intensified mixing and meeting the requirements of vaporization, achieve stability, protect the environment and save energy. Compared with similar equipment at home and abroad, it has the advantages of strong practicability, convenient purchase of spare parts and convenient operation and maintenance.